Jelly Filled Copper Cable (Armoured / Unarmoured)

Features

• Ideally suited for extreme hot & cold weather condition
  
• Ideal for water logging areas
  
• Highest clarity in communication
  
• Absence of cross talk
  
• Free from dermatic hazard
  
• Easier to handle and less maintenance
  
• Free from rodent attack

Polythene (Solid/Foam/Foam Skin) Insulated Jelly Filled Cables (5 Pair to 400 pair)

Description: Twisted pair cable-with solid/foam/foam skin polythene insulated copper conductor, jelly filled, polythene sheathed, bonded poly-Al moisture barrier, unarmored/ armored polythene jacket underground cable.

Application: This type of cable is meant for inter exchange and for local network use. This cable may be unarmored/armored type.

Overhead Cables & Wires Aerial Cables

Description: Polythene insulated self-supporting aerial cable in which suspension wire and the cable core are contained in a single polythene jacket of a figure of 8 sections.

Application: The cable is intended for use as a telephone distribution cable and would be suspended from posts using fixtures. These are normally used in rural/hilly areas.

PCM Cables

Description: Solid round copper conductor, polythene insulated jelly filled poly-Al moisture barrier bonded polythene sheathed underground telecom cable usable for 2 Mb/s digital System.

Application: This cable is intended as a transmission medium for carrying 2 Mb/s digital signal.

Optical Fibre Cables Central Loose Tube

Description: The cable is of Central Loose Tube (CLT) structure. Single Mode Optical Fibres are placed in a Loose Tube and jelly is applied during the extrusion process. Three FRP’s are embedded in the sheathing.

Application: Trunk & Junction Network, T.V. Distribution, Data Links, Telemetry, Short span aerial application on existing open air alignment network.

Slotted Core

Description: Primary coated single mode optical fibre is placed in the helical slots of a central strength member extruded with polypropylene. The Cable core is polyethylene sheathed and Nylon jacketed to make it rodent resistant and termite proof.

Application: Trunk & Junction Network, T.V. Distribution, Data Links, and Telemetry

Aerial Optical Fibre Cables

Description: The cable is of Central Loose Tube (CLT) structure. Single Mode Optical Fibres are placed in a Loose Tube and filled with jelly. Over the loose tube a thin layer of jelly is applied during the extrusion process. Three FRP’s are embedded in the sheathing. To make it suitable for aerial Application Aramide Yarn is raped over the sheathing and then it is jacketed with Nylon.

Application: Trunk & Junction Network in hilly areas & Data Link in hilly areas.